Edit meta description
Edit page URL
Close edit interface
TUTO: Changing the clutch GENERIC TYPE AMXNUMX - XNUMXfactory .comFind out how to change the clutch on your boxed motorcycle with GENRIC TYPE engine AMXNUMX . Technical and detailed guide. 
Loading ...
Moto XNUMX 
Scooter 
Moped 
Off-road motorcycle 
Dirt , Pit Bike 
Moto XNUMX 
Moto 
Solex 
Pocket 
maxi scooter 
Vespa 
TUTORIAL CHANGING YOUR CLUTCH ON A BOI XNUMX MOTORCYCLETE KSR TYPE, GENERIC
Ce tutorial aims at you help change the clutch from your XNUMX to box thanks to pics and explanations associated. In this example, it is a KSR type engine, GENERIC , HANWAY. Don't forget to order the right one clutch for your boxed XNUMXcc motorcycle.
Difficulty :
Temp s necessary:
XNUMX time
HOW TO CHANGE YOUR TYPE ENGINE CLUTCH AM6
1) Remove your kick and kick stop.
2) Drain the oil from the gearbox, removing the drain screw.
3) Let the oil run into the drain pan.
4) Remove the drain screw from the coolant tank.
5) Open the cap of the coolant tank to draw in air.
6) Let the coolant drain into the drain pan.
7) Loosen the hose clamps on the hose.
8) Remove the cooling hose.
9) Remove the oil pump housing (XNUMX screws).
11) Remove the throttle cable.
11) Remove the oil pump (XNUMX screw).
11) Remove the clutch housing (XNUMX screws).
11) Use the mallet to remove the clutch cover.
11) Remove the pressure plate (XNUMX screws, XNUMX washers, XNUMX springs).
11) Remove used discs.
11) Immerse the new discs in box oil.
11) Install a trimmed disc, then a smooth disc. Reno uvel the operation. Finish par a garnished disc.
11) Replace the pressure plate. Pay attention to the direction of the board (small arrow engraved on the board). Replace the springs, washers and screws.
11) Tighten fully.
11) Replace a new clutch housing gasket.
11) Replace the clutch housing by aligning the gears. Remember to reposition the clutch housing gasket.
11) Using the mallet, tap to properly position the housing.
11) Tighten the clutch cover (XNUMX screws), tighten properly.
11) Tension the kick spring, and put the kick stopper.
11) Screw the kick back on.
11) Replace the oil pump (XNUMX screw).
11) Replace the throttle cable.
11) Replace the oil pump housing (XNUMX screws).
11) Replace the bleed screw for coolant.
11) Replace the cooling hose.
11) Tighten the hose clamps.
11) Remove the clutch cover.
11) Remove the gearbox oil level screw.
11) Fill up with transmission oil. When the oil comes out of the level screw hole, the oil level is good. The motorcycle should be straight.
11) Replace the oil level screw.
11) Replace the clutch cover.
11) Fill up with coolant.
Replacement of a clutch on a type K engineSR GENERIC takes time and patience. You will find on our site all the pieces needed for changing your clutch like clutch discs, pressure plate, clutch springs, clutch bell ... etc.
Find out on XNUMXfactory .com every consumables , lubricants et cleaning products for regular maintenance of your machine.
VIDEO: CHANGING TYPE ENGINE CLUTCH AM6 (GENERIC , KSR ...) XNUMX% of products shown as in stock actually are!
