Parts and equipment for motorcycles, quads, scooters and bicycles

Tubeless tire puncture repair kit with Chaft "braid" wicks

34,80

OU9058

IN STOCK

Delivery possible on Tuesday 15 October

Get 3 Points fidelity0,60


CHAFT

We also recommend

Description

Chaft repair kit for tubeless tires

Universal tubeless tire repair kit for motorcycle, scooter, quad, moped, bicycle, car, car, trailer, truck, van, ride-on mower...

This puncture repair kit allows you to seal the puncture area after removing the body.ranger (nail, screw, etc.) from your tire (without removing it) so that you can continue your journey in complete safety without damaging your wheel. For these wicks, we speak of repair par outside, par opposition to reparation par mushroom which is done from the inside of the tire with a patch (removal of the tire necessary).
This kit can be used if the puncture is present on the tread and not on the sidewall of the tire, the puncture diameter must be less than 6 mm and the internal structure of the tire must not be damaged. teriorepar the puncture. It is also necessary that the tire has never run flat and that it has not already undergone a repair before.

This set includes

  • 1 x drilling tool
  • 1 x bit tool
  • 3 x inflation cartridges
  • 1 x valve fitting with adapter
  • 5 x locks (braids)
  • 1 x glue tube
  • 1 x blade
  • 1 x storage case
  • 1 x instructions for use

Technical characteristics and dimensions of the puncture repair kit

  • Brand: Chaft
  • Drill Bit Length: 100 mm
  • Drill Bit Diameter: 5 mm
  • Dimensions of the kit: 114x170x64 mm

The steps to follow to repair your flat tire (see typical diagram)

  • We advise you to use a pair of gloves when using this kit
  • Step 1: Locate the cause of the puncture then remove the body estranger using pliers or pliers.
  • Step 2: Push the drill tool into the hole and shape the hole par a back-and-forth movement.
  • Step 3: Grasp a wick using pliers (be careful of the glue), then insert the wick halfway into the needle of the tool.
  • Step 4: Press the drill bit into the hole in the tire using the tool, while performing a right/left twisting motion. Continue until the ends of the wick no longer stick out more than 2 inches.
  • Step 5: Place the wick in the tire by turning the tool a quarter turn then, pull the tool out sharply.
  • Step 6: Cut the ends of the wick to 3 mm from the tire and re-inflate it.
  • Once repaired, be sure to check and readjust your tire pressure.

Products already seen

HERE 100% OF THE PARTS INDICATED IN STOCK REALLY ARE!