Parts and equipment for motorcycles, quads, scooters and bicycles

Troubleshooting > Failures par brand > APRILIA > APRILIA MX 50 > The grips of my motorcycle APRILIA MX 50 does not hold

The grips of my motorcycle APRILIA MX 50 does not hold

The handles your APRILIA MX 50 generally wear out quite quickly. They are used for comfort, and also sometimes serve as a decorative element and look for enthusiasts. In this article you will learn how to quickly change your handles coating (also called grips). This relatively easy operation is done using a lubricant and a screwdriver dish, all in about ten minutes.

Change the handles of my APRILIA MX 50

1) Remove the old ones handles.

2) Clean the entire tube with ends included. It is important to install handles on a clean surface so as not to block the handle grip gas.

3) Spray glue in aerosol, put gasoline, soap (bar of soap), neoprene glue, hairspray, a few turns of chatterton, a piece of chamber Air

4) Whatever product you use, let it dry (between 24 and 48 hours).

motorcycle battery failure 50

There is also brake wire to tighten the handles . This technique is mainly used on motorbikescross and in quad. On your motorbike APRILIA MX 50, as well as on a quad or a scooter, both handles do not have the same size. Indeed the handle grip accelerator (right side) has a larger diameter than the other. There are a variety of shapes, styles and colors available for handles . The choice of handles will depend on your taste. The handlebars have two sizes 22 and 28 mm.

Tutorials for your APRILIA MX 50


HERE 100% OF THE PARTS INDICATED IN STOCK REALLY ARE!