Parts and equipment for motorcycles, quads, scooters and bicycles

Troubleshooting > Failures par brand > DERBI > DERBI SENDA R DRD PRO 50 > The grips of my motorcycle DERBI SENDA R DRD PRO 50 do not hold

The grips of my motorcycle DERBI SENDA R DRD PRO 50 do not hold

The handles your DERBI SENDA R DRD PRO 50 usually wears out pretty quickly. They are used for comfort, and also sometimes act as a decorative and look element for enthusiasts. In this article you will learn how to quickly change your handles coating (also called grips). This relatively easy operation is done using a lubricant and a screwdriver dish, all in about ten minutes.

Change the handles of my DERBI SENDA R DRD PRO 50

1) Remove the old ones handles.

2) Clean the entire tube with ends included. It is important to install handles on a clean surface so as not to block the handle grip gas.

3) Spray glue in aerosol, put gasoline, soap (bar of soap), neoprene glue, hairspray, a few turns of chatterton, a piece of chamber Air

4) Whatever product you use, let it dry (between 24 and 48 hours).

motorcycle battery failure 50

There is also brake wire to tighten the handles . This technique is mainly used on motorbikescross and in quad. On your motorbike DERBI SENDA R DRD PRO 50, same as on a quad or a scooter, both handles do not have the same size. Indeed the handle grip accelerator (right side) has a larger diameter than the other. There are a variety of shapes, styles and colors available for handles . The choice of handles will depend on your taste. The handlebars have two sizes 22 and 28 mm.

Tutorials for your DERBI SENDA R DRD PRO 50


HERE 100% OF THE PARTS INDICATED IN STOCK REALLY ARE!