Parts and equipment for motorcycles, quads, scooters and bicycles

Troubleshooting > Failures par brand > Spigaou > The handles of my 50cc SPIGAOU motorcycle do not hold

My 50cc SPIGAOU Motorcycle's Grips Won't Hold

The handles of your 50cc SPIGAOU usually wear out quite quickly. They are used for comfort, and also sometimes act as a decorative and look element for enthusiasts. In this article you will learn how to quickly change your handles coating (also called grips). This relatively easy operation is done using a lubricant and a screwdriver dish, all in about ten minutes.

Change the grips of my 50cc SPIGAOU

1) Remove the old ones handles.

2) Clean the entire tube with ends included. It is important to install handles on a clean surface so as not to block the handle grip gas.

3) Spray glue in aerosol, put gasoline, soap (bar of soap), neoprene glue, hairspray, a few turns of chatterton, a piece of chamber Air

4) Whatever product you use, let it dry (between 24 and 48 hours).

motorcycle battery failure 50

There is also brake wire to tighten the handles . This technique is mainly used on motorbikescross and quad. On your 50cc SPIGAOU motorcycle, as well as on a quad or scooter, both handles do not have the same size. Indeed the handle grip accelerator (right side) has a larger diameter than the other. There are a variety of shapes, styles and colors available for handles . The choice of handles will depend on your taste. The handlebars have two sizes 22 and 28 mm.

The tutorials for your 50cc SPIGAOU


HERE 100% OF THE PARTS INDICATED IN STOCK REALLY ARE!