Parts and equipment for motorcycles, quads, scooters and bicycles

Troubleshooting > Failures par brand > YAMAHA > YAMAHA TZR 50 > The grips of my YAMAHA motorcycle TZR 50 do not hold

The grips of my YAMAHA motorcycle TZR 50 do not hold

The handles of your YAMAHA TZR 50 usually wears out pretty quickly. They are used for comfort, and also sometimes act as a decorative and look element for enthusiasts. In this article you will learn how to quickly change your handles coating (also called grips). This relatively easy operation is done using a lubricant and a screwdriver dish, all in about ten minutes.

Change the grips of my YAMAHA TZR 50

1) Remove the old ones handles.

2) Clean the entire tube with ends included. It is important to install handles on a clean surface so as not to block the handle grip gas.

3) Spray glue in aerosol, put gasoline, soap (bar of soap), neoprene glue, hairspray, a few turns of chatterton, a piece of chamber Air

4) Whatever product you use, let it dry (between 24 and 48 hours).

motorcycle battery failure 50

There is also brake wire to tighten the handles . This technique is mainly used on motorbikescross and quad. On your YAMAHA motorcycle TZR 50, same as on a quad or a scooter, both handles do not have the same size. Indeed the handle grip accelerator (right side) has a larger diameter than the other. There are a variety of shapes, styles and colors available for handles . The choice of handles will depend on your taste. The handlebars have two sizes 22 and 28 mm.

Tutorials for your YAMAHA TZR 50


HERE 100% OF THE PARTS INDICATED IN STOCK REALLY ARE!