Universal hydraulic brake switch 10x1.00 mm Fifty (straight wiring)

Rear universal brake sensor motorcycle, quad ...

The rear brake switch is an essential part of the braking system of your two-wheeler. This brake lever switch for rear brake light lighting is new and adaptable for motorcycle, scooter, kart cross, car cross, sprint car, buggy, go kart...

It is mainly mounted on rear brake circuits, but it is also compatible for front hydraulic brake circuits depending on the assemblies.

Technical characteristics and dimensions of the 10x100 contactor

• Mark: Fifty moto parts
• Number of terminals: 2
• Overall length: 315 mm
• Thread diameter: 10 mm
• No 1.00 thread

Find our electricity accessories, as well as all lighting parts for your machine. Also discover our selection oftools for the maintenance of your two wheels.

Frequently Asked Questions

What is the brake switch?

The brake switch is a device that activates the brake light when you brake. It is usually located on the brake lever or on the brake circuit. It is essential for safety, car It signals to other road users that you are braking.

How to change a stop switch?

Replacing a brake switch is a relatively simple job. All you have to do is disconnect the old switch, unscrew it, and screw the new one in place. Make sure to reconnect the electrical wires properly and check that the brake light is working properly before you get back on the road.

How do you know if the brake switch is faulty?

If your brake light doesn't come on when you brake, your brake switch may be faulty. You can check its condition by using a multimeter to measure electrical continuity. If there is no current flowing, the switch is probably bad and needs to be replaced.