Electronic ignition (big cone) 12V Peugeot 103 Fifty

Ignition 12V Peugeot 103, ideal for switching from ignition switch to electronic ignition

Ignition and rotor stator assembly, coil and bell, new adaptable for moped, moped 50cc Peugeot 103 Clip, Chrono, MVL, RCX, SPX, SP, Vogue...
The green / yellow wire with the flat terminal (CDI output) does not connect to the high voltage coil, this wire is a circuit breaker. For the connection, you need to make a shunt (U) with the round lugs connect them together with the screw that holds the high voltage coil (coil support) and then connect a wire that connects the green / yellow (round lug) to go to the flat terminal of the high voltage coil.

Ignition kit technical characteristics and dimensions

• Mark: Fifty moto parts
• Ignition 12 volts
• Total number of shots: 4
• Number of terminals: 8
• Outer diameter stator: 100 mm
• Inner diameter rotor: 100 mm
• Rotor outer diameter: 126 mm
• Sensor fixing center distance: 36 mm
• Large cone rotor to switch from a spark ignition to an electronic ignition
• Green wires voltage regulator output lighting
• The green / yellow wire with the flat terminal (CDI output) does not connect to the high voltage coil, this wire is a circuit breaker. For the connection, you must make a shunt (U) with the round terminals connect them together with the screw that holds the high voltage coil (coil support) and then connect a wire that connects the green / yellow (round terminal) to go to the flat terminal of the high voltage coil.

Learn all about the differences between a "big cone" and a "small cone" by clicking on this link.