Crankshaft Bearing Installation Tool Derbi, AM6 minarelli, Piaggio, Peugeot, Minarelli... Easyboost

Crankshaft Bearing Installation Tool Easyboost

New low engine crankshaft bearing assembly rings and washers kit adaptable for motorbike, scooter, moped, quad motor Derbi, AM6 minarelli, Piaggio, Minarelli, Peugeot...
The bearing mounting tool is used simply by screwing the special nut on the crankshaft, then inserting the aluminum tube with the screw equipped with a nut, two thick washers and a stopper (needle bearing). By turning the thrust nut using a spanner, the bearing will gradually move into place on the crankshaft until it comes to a stop.

Includes

• 2 x mounting tubes (depending on type of crankshaft)
• 2 x clamping washers
• 1 x Needle washers bearing
• 1 x clamping screw
• 2 x nuts Ø10x1.00 mm
• 1 x special nut (double) Ø10x1.25 mm / Ø10x1.00 mm (to fit all models)
• 1 x manual

Technical characteristics and dimensions of the clip

• Mark: Easyboost
• Tube material: aluminum
• Material of screw and nuts: steel
• Tube lengths: 86 mm and 115 mm
• Inner diameter of the tubes: 20 mm
• Outside diameter of the tubes: 25.5 mm