General information > Tips and Guides > Tutorials > Off-road motorcycle > Equipment > Replace a Roll-off on a mask cross
Ce tutorial aims at you help replace the Roll-off system on your mask cross. Discover on our site all the masks, screens and roll-off and tear-off systems for off-road and quad riding.
Find our guide: How to choose the right mask
Difficulty :
Temps necessary:
5 minutes
Necessary material:
1) Press the clip to open the cover on each side and remove the covers.
2) The new Roll-off is installed on the left part of the mask. Insert the roll-off roller in the location opposite the pull tab, respecting the direction indicated on the roller.
3) It is positioned at the level of the supports on the side.
4) Stretch and place the Roll-off below the mud-flap. The plastic film must go under the mud-flap.
5) Wind the adhesive tape from the beginning of the Roll-off roll onto the swivel support.
6) Insert the media into its slot.
7) Check that the Roll-off is correctly placed under the mud-flap.
8) Replace the covers (left side then right side).
9) Using the pull tab, check that the Roll-off slides correctly. Press the right cover to create resistance on the Roll off and activate the pull tab to unwind the new film and tighten it.
The Roll-off strip will remove the waste that bothers you in your field of vision. It may happen that on certain races tear-offs are prohibited for ecological reasons, the Roll-off is therefore an excellent alternative.
Hint: add a piece of tape to the top of the Roll-off cover to ensure the complete closure of your Roll-off and prevent the worn part from bothering you.
Another tip: stick a piece of mud flap to the right side of the mask - it will remove dirt when rolling up the used film and ensure better use of the Roll-off.