Battery voltage indicator 6 - 73V

Universal battery charge level indicator

New power battery charge light adaptable for motorcycle, scooter, quad, motorbike cross, enduro 50cc, 125cc and other cylinders.
The indicator is for lead acid batteries with a rated voltage of 12V, 24V, 36V, 48V (8-70V) and lithium batteries of 3,7V.

Technical characteristics and dimensions of the led battery tester

• Brand: generic
• Material : plastic
• Colour: black
• Length: 57 mm
• Width: 28 mm
• Height: 13 mm
• Dial length: 61 mm
• Dial Width: 33 mm
• Cable length: 300 mm
• 2 wire connection
• 2 buttons

Operating modes :
S1 - The charge level indicator displays alternately with the current voltage in a 2 second cycle.
S2 - After pressing the button, the indicator lights up for 10 seconds and then turns off to save power.
S3 - The indicator lights up when the button is pressed.
S4 - The indicator shows the logo (applies to the mode with a small battery icon). The logo icon is located below the battery symbol on the left side of the screen. Turn on to display the logo.
S5 - Selection of discharge mode. Shows two types of battery discharge curve. Different conditions are transformed to determine the correct discharge mode.

Entering parameters:
1. Disconnect the module from the power supply. Press and hold the settings button, reconnect the power and release the button. The screen will display the current adjustment parameters.
2. Press the setting button in the sequence P/L/F (P - 12V lead acid battery, L - 3,7V lithium cell, F - 3,2V LiFePo cell).
3. Press the function button to set the number of cells in the battery.
4. Long press the function button to enter advanced settings mode. Use the adjustment button to select S1-S5. Confirm with the Enter button to select or cancel the current mode.
5. Reconnect the power after making adjustments. The settings will be saved automatically.

Ex.: S1 mode (alternating display of charge and voltage) for 10 cell lithium battery - Unplug the power, press and hold the setting button, plug in the power, short press the setting button to select L, press the button to select 10, press and hold the
function button to select S1 and connect to power supply.